Characteristic of 2-D supersonic inlet with auxiliary intake at low flight speed

FU Xiaogang; LI Junhao; XU Yanzhi

doi:10.11729/syltlx20190129

Volume 34 Issue 5

Oct. 2020

Turn off MathJax

Article Contents

Article Navigation > Journal of Experiments in Fluid Mechanics > 2020 > 34(5): 36-43

FU Xiaogang, LI Junhao, XU Yanzhi. Characteristic of 2-D supersonic inlet with auxiliary intake at low flight speed[J]. Journal of Experiments in Fluid Mechanics, 2020, 34(5): 36-43. doi: 10.11729/syltlx20190129

Citation:

PDF( 17959 KB)

Characteristic of 2-D supersonic inlet with auxiliary intake at low flight speed

doi: 10.11729/syltlx20190129

Aero Propulsion Institute of Chinese Flight Test Establishment, Xi'an 710089, China

Received Date: 2019-10-09
Rev Recd Date: 2020-04-04
Publish Date: 2020-10-25

Abstract

Abstract

Through the flight test, the internal flow field distribution and the inlet distortion of the 2-D supersonic inlet with the auxiliary intake door at low speed are investigated. The results show that mixing of the auxiliary intake flow and the main flow in the inlet would produce a low total pressure area in the downstream area of the auxiliary intake door, causing the distortion to increase and the total pressure recovery to decrease. Besides, the auxiliary intake flow rate and the resulting distortion increase with the increase of the engine speed, decrease with the increase of the flight Mach number, and there is no significant difference when the flight altitude changes. Meanwhile, the range of the low total pressure area and the distortion produced by the auxiliary intake flow increase when the sideslip angle increases to the left and right, and there is no obvious difference when the attack angle changes. In addition, by analyzing the correlation between the change of the low total pressure area at the outlet section of the inlet and the flow coefficient of each test point, the operating range corresponding to the opening and closing status of the auxiliary intake door is determined.
- inlet,
- auxiliary intake door,
- flow coefficient,
- inlet distortion,
- flight test

FullText(HTML)

References(15)

References

[1]	SCHARNHORST R K. An overview of military aircraft supersonic inlet aerodynamics[R]. AIAA 2012-0013, 2012.
[2]	廉筱纯, 吴虎.航空发动机原理[M].西安:西北工业大学出版社, 2005.
[3]	DENNER B W, MCCALLUM B N, TRUAX P P. CFD prediction of inlet spill drag increments[R]. AIAA 98-3566, 1998.
[4]	CHUN K S, BURR R H. A control system concept for an axisymmetric supersonic inlet[J]. Journal of Aircraft, 1969, 6(4):306-311. doi: 10.2514/3.44056
[5]	NORMAN E SORENSEN, DONALD B SMELTZER. Study of a family of supersonic inlet system[J]. Journal of Aircraft, 1969, 6(3):32-34. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=CC027856452
[6]	HUNTER L G, CAWTHON J A. Improved supersonic performance for the F-16 inlet modified for the J79 engine[J]. Journal of Propulsion and Power, 1985, 1(1):50-57. doi: 10.2514/3.22758
[7]	MIKI H, KAMEDA M, WATANABE Y. Low drag design and aerodynamic performance evaluation of supersonic air inlet[R]. AIAA-2014-3798, 2014.
[8]	张堃元, Meier G E A.二元进气道非均匀超音来流试验研究[J].推进技术, 1993, 14(1):9-15. http://www.cqvip.com/QK/97609X/19931/1190013.html ZHANG K Y, MEIER G E A. Experimental investigation of 2-d inlet model in non-uniform supersonic flow[J]. Journal of Propulsion Technology, 1993, 14(1):9-15. http://www.cqvip.com/QK/97609X/19931/1190013.html
[9]	卢燕, 樊思齐.超声速进气道内特性数值模拟及性能分析[J].飞机设计, 2003, 23(3):10-13. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=fjsj200303003 LU Y, FAN S Q. Static internal performance analysis and numerical simulation of supersonic inlet[J]. Aircraft Design, 2003, 23(3):10-13. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=fjsj200303003
[10]	崔立堃, 李卓.二元超音速进气道设计与研究[J].科学技术与工程, 2013, 13(27):8070-8073, 8081. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=kxjsygc201327025 CUI L K, LI Z. Design and study of two-dimensional supersonic projectile inlet[J]. Science Technology and Engineering, 2013, 13(27):8070-8073, 8081. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=kxjsygc201327025
[11]	时瑞军, 卢贤锋, 樊思齐.超音速进气道建模方法研究[J].航空动力学报, 2004, 19(4):466-471. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkdlxb200404007 SHI R J, LU X F, FAN S Q. Investigation of supersonic inlet mathematical model with attack angle[J]. Journal of Aerospace Power, 2004, 19(4):466-471. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkdlxb200404007
[12]	何中伟, 张世英, 李君山, 等.二元超音速进气道唇口分离流动及其控制[J].推进技术, 1986, 6(3):2-8. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=228244
[13]	何中伟.二元超音速进气道进气口内流动的动态特性及相干分析[J].南京航空学院学报, 1988, 20(1):72-79. http://www.cnki.com.cn/Article/CJFDTotal-NJHK198801010.htm
[14]	YOUNG D, JENKINS S, MILLER D. An investigation of active flowfield control for inlet shock/boundary layer interaction[R]. AIAA-2005-4020, 2005.
[15]	SLATER J. Design and analysis tool for external-compression supersonic inlets[R]. AIAA-2012-0016, 2012.