Citation: | ZHU Xinxin, WANG Hui, YANG Kai, et al. Research on heat flux calculation and correction methods of the slug calorimeter[J]. Journal of Experiments in Fluid Mechanics, 2020, 34(5): 97-102, 108. doi: 10.11729/syltlx20190134 |
[1] |
朱超, 陈德江, 周玮, 等.电弧风洞CO2介质运行分析[J].实验流体力学, 2015, 29(1):31-36. http://www.syltlx.com/CN/abstract/abstract10804.shtml
ZHU C, CHEN D J, ZHOU W, et al. Evaluation of arc-heated wind-tunnel operation in CO2 atmosphere[J]. Journal of Experiments in Fluid Mechanics, 2015, 29(1):31-36. http://www.syltlx.com/CN/abstract/abstract10804.shtml
|
[2] |
刘强, 崔赢午, 陈志会, 等.高气动加热环境下运载器局部防热设计与试验研究[J].强度与环境, 2016, 43(1):54-59. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=qdyhj201601010
LIU Q, CUI Y W, CHEN Z H, et al. The study on topical TPS design for hypersonic aerocraft[J]. Structure & Environment Engineering, 2016, 43(1):54-59. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=qdyhj201601010
|
[3] |
欧阳金栋, 刘慧慧, 邓进, 等.高超声速飞行器结构热防护技术现状综述[J].教练机, 2017(1):39-43. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hongdkj201701007
OUYANG J D, LIU H H, DENG J, et al. Research status of structural thermo protection technology for hypersonic speeding missile[J]. Hongdu Science and Technology, 2017(1):39-43. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hongdkj201701007
|
[4] |
王璐, 王友利.高超声速飞行器热防护技术研究进展和趋势分析[J].宇航材料工艺, 2016, 46(1):1-6. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=yhclgy201601001
WANG L, WANG Y L. Research progress and trend analysis of hypersonic vehicle thermal protection technology[J]. Aerospace Materials & Technology, 2016, 46(1):1-6. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=yhclgy201601001
|
[5] |
孟松鹤, 丁小恒, 易法军, 等.高超声速飞行器表面测热技术综述[J].航空学报, 2014, 35(7):1759-1775. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkxb201407001
MENG S H, DING X H, YI F J, et al. Overview of heat measurement technology for hypersonic vehicle surfaces[J]. Acta Aeronautica et Astronautica Sinica, 2014, 35(7):1759-1775. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=hkxb201407001
|
[6] |
刘初平.气动热与热防护试验热流测量[M].北京:国防工业出版社, 2013.
|
[7] |
NAWAZ A, SANTOS J A. Assessing calorimeter evaluation methods in convective heat flux environments[C]//Proc of the 10th AIAA/ASME Joint Thermophysics and Heat Transfer Conference. 2010.
|
[8] |
NAWAZ A, GORBUNOV S, TERRAZAS-SALINAS I, et al. Investigation of slug calorimeter gap influence for plasma stream characterization[C]//Proc of the 43rd AIAA Thermophysics Conference. 2012.
|
[9] |
杨庆涛, 白菡尘, 张涛, 等.隔热结构对塞块式量热计热流测量的影响[J].实验流体力学, 2014, 28(5): 92-98. http://www.syltlx.com/CN/abstract/abstract10780.shtml
YANG Q T, BAI H C, ZHANG T, et al. Effects of adiabatic structure on heat flux measurement using a slug calorimeter[J]. Journal of Experiments in Fluid Mechanics, 2014, 28(5): 92-98. http://www.syltlx.com/CN/abstract/abstract10780.shtml
|
[10] |
许考, 陈连忠.导管内塞式量热计热流测量实验及数值模拟研究[J].实验流体力学, 2015, 29(2): 84-89. http://www.syltlx.com/CN/abstract/abstract10832.shtml
XU K, CHEN L Z. Experimental and numerical simulation studies on heat flux measurement for slug calorimeters in the conduit[J]. Journal of Experiments in Fluid Mechanics, 2015, 29(2): 84-89. http://www.syltlx.com/CN/abstract/abstract10832.shtml
|
[11] |
朱新新, 杨庆涛, 王辉, 等.塞块式量热计隔热结构的改进与试验分析[J].实验流体力学, 2018, 32(6): 34-40. http://www.syltlx.com/CN/abstract/abstract11153.shtml
ZHU X X, YANG Q T, WANG H, et al. Improvement of heat insulation structure in the slug calorimeter and test analysis[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(6): 34-40. http://www.syltlx.com/CN/abstract/abstract11153.shtml
|
[12] |
陈连忠.塞块式瞬态量热计测量结果修正方法的研究[J].计量学报, 2008(4): 317-319. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=jlxb98200804007
CHEN L Z. A calibration method on the result of transient plug type heat flux meter[J]. Acta Metrologica Sinica, 2008(4): 317-319. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=jlxb98200804007
|
[13] |
MARK HIGHTOWER T, OLIVARES R A, et al. Thermal capacitance (slug) calorimeter theory including heat losses and other decaying processes[R]. NASA/TM-2008-215364, 2008.
|
[14] |
MURTHY A V, TSAI B K, SAUNDERS R D. Radiative calibration of heat-flux sensors at NIST: facilities and techniques[J]. Journal of Research of the National Institute of Standards and Technology, 2000, 105(2):293-305. doi: 10.6028/jres.105.033
|
[15] |
朱新新, 王辉, 杨庆涛, 等.弧光灯热流标定系统的光学设计[J].光学学报, 2016, 36(11): 227-233. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=gxxb201611028
ZHU X X, WANG H, YANG Q T, et al. Optical design of arc lamp heat flux calibration system[J]. Acta Optica Sinica, 2016, 36(11): 227-233. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=gxxb201611028
|
[16] |
石逸武, 罗永祥, 许喜銮, 等.硅油及填料对导热硅脂接触热阻的影响[J].电子与封装, 2013, 13(8): 30-33. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=dzfz201308009
SHI Y W, LUO Y X, XU X L, et al. Effect of silicone oil and filler on thermal resistance of thermal conductive grease[J]. Electronics and Packaging, 2013, 13(8): 30-33. http://www.wanfangdata.com.cn/details/detail.do?_type=perio&id=dzfz201308009
|